DYNATEK

Dyna Program Kit 2000-i

Part # 2101-0012

• —Completely self-contained so entire unit hides under the cam cover for a clean look on custom bikes
• —Single-fire operation down to zero rpm for easier cranking and kicking
• —Will operate in all combinations of single-fire or dual-fire with single-plug or dual-plug heads
• —Ten advance curves cover a broad range of engine builds and riding styles
• —Engine over-rev protection, adjustable from 6000 to 7500 rpm
• —Adjustable timing retard for nitrous and turbo applications
• —VOES indicator lets you monitor VOES switch at a glance
• —Built-in tach driver can be used to activate shift lights, auto-shifters and other accessories
• —Easy static timing with built-in timing indicator
• —Intelligent over-current/short-circuit protection
• —Active dwell control
• —Over-voltage protected against momentary spikes
• —Data recording includes total engine hours, time wide-open throttle, longest time operating at wide-open throttle, max rpm, seconds near rev limit and number of engine starts
• —PC programmability makes possible an eight-point, fully definable, wide-open throttle curve and a fully definable part throttle curve, rev limit programmable in 50 rpm steps, programmable dead-cranking revs 0-5, rear cylinder offset, total of +/- 10°, programmable rev limiter, security lock out (pin # activated), single or dual fire
• —Programming and downloading data and graphs from module requires proper programming kit (includes CD, cables and instructions)
• —Pigtail connector enables the user to connect the ignition to a PC to either download recorded info from the ignition or program their own power curves, rev limits, dead revs or rear cylinder off-set timing; connector remains on bike
• —Made in the USA
• —Not for fuel-injected models
• —Programming kit is not necessary to use all selectable functions of the current ignition.